Опис
ЦВ0303 voltmeters are designed to measure the rms value of the voltage in networks and circuits of sinusoidal alternating current with a frequency of 50 Hz. Measurement results are displayed on a four-digit LED indicator with a floating point.
Voltmeters, depending on overall dimensions, type of electrical power supply, presence of an interface and accuracy class, are designed in accordance with the scheme:
Voltmeters have an RS-485 interface for transferring measurement results to a personal computer (PC). MODBUS RTU exchange protocol. Exchange speed 9600 Baud. Voltmeters can have a network address from 1 to 250.
Voltmeters with an interface have two relay outputs that ensure the closing of the relay contacts when the measured value of the set value of the upper and lower settings is reached. Setting the setting value is carried out from the PC.
The final value of the measurement range of direct connection voltmeters is from 7.5 V to 600 V. Voltage measurements above 600 V are made by connecting them through a voltage transformer.
The final value of the measurement range of voltmeters corresponds to the value from row 1; 1,2; 1.5; 2; 2.5; 3; 4; 5; 6; 7.5; 8 or their multiples of decimal and fractional values. At the request of the customer, it is possible to make voltmeters with a different final value of the measurement range.
The range of readings of voltmeters is from zero to 1.2 the final value of the measurement range.
The initial value of the measurement range is equal to 0.1 of its final value.
The resolution of voltmeters is no more than 0.002 of the final value of the measurement range
Accuracy class – 0.5 / 0.5 or 1 / 0.5 according to DSTU OIML R 34:2014 Accuracy classes of measuring equipment.
Power supply of voltmeters is from a direct current network or an alternating current network with a frequency of (50 ± 0.2) Hz, voltage from 100 V to 250 V. The power consumption of the voltmeter from the power source is no more than 3 V×A.
Working conditions of application:
– ambient air temperature from minus 30 ºС to plus 50 ºС;
– relative air humidity up to 90% at a temperature of 30 ºС.
Mass of ammeters, no more than:
TsV0303-2 – 0.25 kg,
TsV0303-3, – 0.2 kg.
Degree of protection provided by the ammeter housing against penetration of solid objects, IP30 according to ДСТУ EN 60529:2014
Degrees of protection provided by enclosures (IP).
Installation dimensions for attaching voltmeters to the shield are shown in the figure:
|
Device |
С, mm |
|
ЦВ0303-2 |
92+0,8 |
|
ЦВ0303-3 |
68+0,7 |
The method of attaching and removing voltmeters to the shield is shown in the figures:
The diagram for connecting voltmeters without an interface is shown in the figure:
The connection scheme of voltmeters with the interface is shown in the figure:
